Sensor, Coolant Temperature: Installation: 3.0L

WARNING: This page is about a different car, the 2014 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Temperature Sensor & Thermostat Housing

Courtesy of CHRYSLER GROUP, LLC

Apply MOPAR® thread sealant with PFTE to the sensor threads.
Install the coolant temperature sensor (2) into water pump housing (3). Tighten the coolant temperature sensor (2) to 11 N.m (97 in. lbs.).

Fig 2: Coolant Temperature Sensor Wire Harness Connector
Courtesy of CHRYSLER GROUP, LLC
Connect the coolant temperature sensor wire harness connector (1).

Fig 3: Removing/Installing Engine Cover
Courtesy of CHRYSLER GROUP, LLC
Install the engine cover (1).
Replace any lost engine coolant. Refer to STANDARD PROCEDURE .