LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 534 (3.0L Diesel (Service Information) 1500) >> Manifolds >> Manifold, Exhaust >> Removal >> Left Bank

Left Bank

WARNING: This page is about a different car, the 2014 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

The normal operating temperature of the exhaust system is very high. Therefore, never work around or attempt to service any part of the exhaust system until it has cooled. Special care should be taken when working near the catalytic converter. The temperature of the converter rises to a high level after a short period of engine operation time.

Fig 1: Removing/Installing Engine Cover
GC0158138Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect the negative battery cable.
  2. Remove the engine cover (1).
  3. Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
  4. Drain the cooling system. Refer to STANDARD PROCEDURE .
  5. Remove the transmission. Refer to REMOVAL .
  6. Remove the serpentine belt (2). Refer to BELT, SERPENTINE, REMOVAL .
    NOTE:

    Removal of the A/C compressor does not require the refrigerant to be evacuated.

  7. Remove the rear A/C compressor mounting bolt.
  8. Remove the A/C compressor nut and stud.
  9. Remove bolt and the A/C compressor and position aside.
    Fig 2: A/C Compressor Bracket & Bolts
    GC0146757Courtesy of CHRYSLER GROUP, LLC
  10. Remove bolts and the A/C compressor mounting bracket
  11. Lower the vehicle.
    Fig 3: Remove/Install Oil Cooler Assembly
    GC0158173Courtesy of CHRYSLER GROUP, LLC
  12. Remove the oil cooler adapter. Refer to ADAPTER, OIL COOLER, REMOVAL .
    Fig 4: Left Exhaust Manifold Heat Shield & Bolts
    GC0146647Courtesy of CHRYSLER GROUP, LLC
  13. Remove bolts (1) and the left exhaust manifold heat shield (2).
    Fig 5: Exhaust Manifold Pipe To Turbocharger Heat Shield & Bolts
    GC0146648Courtesy of CHRYSLER GROUP, LLC
  14. Remove bolts (2) and the exhaust manifold pipe to turbocharger heat shield (1).
    Fig 6: Exhaust Manifold Pipe To Turbocharger Nuts
    GC0146650Courtesy of CHRYSLER GROUP, LLC
  15. Remove the three nuts (1) from exhaust manifold pipe to turbocharger.
    Fig 7: Left Exhausts Manifold & Nuts
    GC0146649Courtesy of CHRYSLER GROUP, LLC
  16. Remove nuts (1) and the left exhausts manifold (2).
  17. Remove and discard gaskets.
scientia non olet · About LEMON Manuals