LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 534 (3.0L Diesel (Service Information) 1500) >> Engine Block >> Seal, Crankshaft Oil, Front >> Installation >> Installation

Seal, Crankshaft Oil, Front: Installation: Installation

WARNING: This page is about a different car, the 2014 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Special Tool #VM.10340-1 & Front Seal
GC0158017Courtesy of CHRYSLER GROUP, LLC
  1. Clean timing chain cover seal surface.
    NOTE:

    Install the front oil seal so the lip of seal face away from the engine.

  2. Install the (special tool #VM.10340-1, Guide, Front Seal) (1) and position the front seal (2) in place.
  3. Remove the (special tool #VM.10340-1, Guide, Front Seal) (1).
    Fig 2: Front Seal Installer Tool & Vibration Damper Bolt
    GC0146773Courtesy of CHRYSLER GROUP, LLC
  4. Using the (special tool #VM.10340-2, Installer Tool, Front Seal) (2), install the front crankshaft oil seal using the vibration damper bolt (3) to draw the seal in place.
  5. Remove bolt (3) and the (special tool #VM.10340-2, Installer Tool, Front Seal) (2).
    Fig 3: Vibration Damper & Bolt
    GC0146664Courtesy of CHRYSLER GROUP, LLC
  6. Install the vibration damper (2). Refer to DAMPER, VIBRATION, INSTALLATION .
  7. Connect the negative battery cable.
scientia non olet · About LEMON Manuals