LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 531 (Heating & Air Conditioning (Service Information) 1500) >> Plumbing >> Line, A/C Suction >> Removal >> 3.6L, 5.7L Engines

3.6L, 5.7L Engines

WARNING: This page is about a different car, the 2014 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Review the warnings and cautions for this system before performing the procedure. Failure to follow these instructions may result in serious injury or death.

  1. Disconnect and isolate the negative battery cable.
  2. Recover the refrigerant from the refrigerant system. Refer to PLUMBING, STANDARD PROCEDURE .
  3. Remove the air filter housing cover and engine air inlet tube. Refer to BODY, AIR CLEANER, REMOVAL, 3.6L or BODY, AIR CLEANER, REMOVAL, 5.7L .
    Fig 1: Remove/Install A/C Discharge Line
    GC0154597Courtesy of CHRYSLER GROUP, LLC
  4. Remove the nut (1) that secures the A/C suction line (2) to the Internal Heat Exchanger assembly.
    Fig 2: A/C Compressor, Drive Belt & Suction/Discharge Lines
    GC0089585Courtesy of CHRYSLER GROUP, LLC
  5. Remove the nut (2) that secures the A/C suction line (1) to the A/C compressor (4).
  6. Disconnect the A/C suction line from the A/C compressor.
  7. Remove the plastic retaining brackets that secure the A/C suction line to the A/C discharge line and to the upper front of the engine.
  8. Remove the A/C suction line from the engine compartment.
  9. Remove and discard the O-ring seals and gaskets from the A/C suction line and install plugs in, or tape over the opened suction line fittings and the expansion valve and compressor ports.
scientia non olet · About LEMON Manuals