LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 531 (Heating & Air Conditioning (Service Information) 1500) >> Plumbing >> Line, A/C Discharge >> Removal >> 4.7L Engine

4.7L Engine

WARNING: This page is about a different car, the 2014 RAM 1500. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Review the warnings and cautions for this system before performing the procedure. Failure to follow these instructions may result in serious injury or death.

Fig 1: A/C Discharge Line
GC0089597Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable.
  2. Recover the refrigerant from the refrigerant system. Refer to PLUMBING, STANDARD PROCEDURE .
  3. Disconnect the wire harness connector from the A/C pressure transducer (2).
  4. Remove the nut (1) that secures the A/C discharge line (4) to the condenser jumper line tapping block (3).
  5. Disconnect the A/C discharge line from the A/C condenser and remove and discard the O-ring seal and gasket.
  6. Remove the nut (6) that secures the A/C discharge line to the A/C compressor (5).
  7. Disconnect the A/C discharge line from the A/C compressor and remove and discard the O-ring seal and gasket.
  8. Install plugs in, or tape over the opened refrigerant line fittings and the compressor and condenser jumper line ports.
  9. If necessary, remove the A/C pressure transducer from the A/C discharge line. Refer to TRANSDUCER, A/C PRESSURE, REMOVAL .
scientia non olet · About LEMON Manuals