LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 512 (Powertrain Control Module (Pcm) - Electrical Diagnostics - 40TE Automatic Transmission) >> DTC Troubleshooting >> P0890-Switched Battery >> Set Condition

Set Condition

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.

A fault is set if the sensed voltage on any of the pressure switch circuits is greater than 4.5 volts for the period of 7 msec before a request by the Transmission Control System requests the Transmission Control Output circuit to be energized. The transmission is placed in Limp-In and the MIL is illuminated after 10 seconds of vehicle operation.

scientia non olet · About LEMON Manuals