Diagnostic Test

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.

ACTIVE DTC
1. Ignition on, engine not running.
2. With the scan too, select View PCM DTCs.
  Is the DTC Active at this time?
  
  Yes
  - Go To 2
  No
  - Perform the INTERMITTENT CONDITION diagnostic procedure. Refer to STANDARD PROCEDURE .
U0141-LOST COMMUNICATION WITH FRONT CONTROL MODULE (TIPM) ALSO ACTIVE
1. With the scan too, select View DTCs.
  Is the U0141-NO BUS MESSAGE RECEIVED FROM THE TIPM also set?
  
  Yes
  - Follow the diagnostics for U0141-LOST COMMUNICATION WITH IPM (FCM/TIPM). Refer to DIAGNOSIS AND TESTING .
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Replace and program the Powertrain Control Module in accordance with the service information.
  - Perform the POWERTRAIN VERIFICATION TEST. Refer to STANDARD PROCEDURE .