Diagnostic Test

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.

CHECK IF THE DTC IS ACTIVE
1. Ignition on, engine not running.
2. With the scan tool, read HVAC DTCs.
  Is this DTC active?
  
  Yes
  - Go To 2
  No
  - Go To 4
CHECK (L24) AUTO HEADLAMPS SIGNAL CIRCUIT FOR A SHORT TO GROUND

Fig 1: Measuring Resistance Between Ground & Auto Headlamps Signal Circuit
Courtesy of CHRYSLER GROUP, LLC
1. Turn the ignition off to the lock position.
2. Disconnect the A/C Heater Control C2 harness connector.
3. Disconnect the Sun Sensor harness connector.
4. Measure the resistance between ground and he (L24) Auto Headlamps Signal circuit.
  Is the resistance below 100k Ohms?
  
  Yes
  - Repair the (L24) Auto Headlamps Signal circuit for a short to ground.
  - Perform the HVAC VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Go To 3
CHECK THE A/C HEATER CONTROL
1. Replace the Sun Sensor in accordance with the Service Information.
2. Perform the HVAC VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  Did this DTC reset while performing the HVAC Verification Test?
  
  Yes
  - Replace and program the A/C Heater Control in accordance with the Service Information.
  - Perform the HVAC VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Test complete.
CHECK THE WIRING AND CONNECTORS
1. The conditions necessary to set the DTC are not present at this time.
2. With the scan tool, check the Environmental Data to help identify the conditions in which the DTC was set.
3. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals, and correct pin tension.
4. Wiggle the wiring and connectors while checking for shorted and open circuits.
  Were there any problems found?
  
  Yes
  - Repair as necessary.
  - Perform the HVAC VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Test complete.