Diagnostic Test

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.

INTERMITTENT CONDITION
1. Turn the ignition on.
2. With the scan tool, clear all TIPM DTCs.
3. Turn the Windshield Wipers on.
4. With the scan tool read the DTC information.
  Does the scan tool read: B234B-WIPER MOTOR HIGH SPEED CONTROL CIRCUIT HIGH?
  
  Yes
  - Go To 2
  No
  - The condition that caused the symptom is currently not present. Inspect the related wiring for a possible intermittent condition. Look for any chafed, pierced, pinched, or partially broken wires.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
(W4) WIPER MOTOR HIGH SPEED CONTROL CIRCUIT OPEN
1. Turn the ignition off.
2. Disconnect the TIPM C11 harness connector.
3. Disconnect the Windshield Wiper Motor harness connector.
4. Measure the resistance of the (W4) Wiper Motor High Speed Control circuit.
  Is the resistance above 5.0 Ohms?
  
  Yes
  - Repair the (W4) Wiper Motor High Speed Control circuit for an open condition.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Go To 3
(W4) WIPER MOTOR HIGH SPEED FEED CIRCUIT SHORTED TO VOLTAGE
1. Turn the ignition off.
2. Disconnect the TIPM C11 harness connector.
3. Disconnect the Windshield Wiper Motor harness connector.
4. Turn the ignition on.
5. Measure for voltage on the (W4) Wiper Motor High Speed Control circuit.
  Is the voltage above 10.0 volts?
  
  Yes
  - Repair the (W4) Wiper Motor High Speed Control circuit for a short to voltage condition.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Replace the TIPM in accordance with the Service Information. Refer to MODULE, TOTALLY INTEGRATED POWER (TIPM), REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .