Diagnostic Test

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.

INTERMITTENT CONDITION
1. Turn the ignition on.
2. With the scan tool, clear all TIPM DTCs.
3. Turn the Washers on.
4. With the scan tool, read the Wiper/Washers DTCs.
  Does the scan tool read: B231F-FRONT/REAR WASHER MOTOR CONTROL CIRCUIT LOW?
  
  Yes
  - Go To 2
  No
  - The condition that caused the symptom is currently not present. Inspect the related wiring for a possible intermittent condition. Look for any chafed, pierced, pinched, or partially broken wires.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
WASHER PUMP MOTOR
1. Turn the ignition off.
2. Disconnect the Washer Pump Motor harness connector.
3. Turn the ignition on.
4. With the scan tool, read the DTCs.
  Does the scan tool read: B231F-FRONT/REAR WASHER MOTOR CONTROL CIRCUIT LOW?
  
  Yes
  - Go To 3
  No
  - Replace the Washer Pump Motor in accordance with the Service Information. Refer to PUMP, WINDSHIELD WASHER, REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
(W10)/(W20) WASHER PUMP MOTOR CONTROL CIRCUITS SHORT TOGETHER

Fig 1: Checking Washer Pump Motor Control Circuits For A Short Together
Courtesy of CHRYSLER GROUP, LLC
1. Turn the ignition off.
2. Disconnect the Washer Pump Motor harness connector.
3. Disconnect the TIPM C1 harness connector.
4. Measure the resistance between the (W10) and (W20) Washer Pump Motor Control circuits.
  Is the resistance below 5.0 Ohms?
  
  Yes
  - Repair the (W10) and (W20) Washer Pump Motor Control circuits for a short together.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Go To 4
(W20) WASHER PUMP MOTOR CONTROL CIRCUIT SHORTED TO GROUND

Fig 2: Checking Washer Pump Motor Control Circuit For A Short To Ground
Courtesy of CHRYSLER GROUP, LLC
1. Measure the resistance between ground and the (W20) Washer Pump Motor Control circuit.
  Is the resistance below 5.0 Ohms?
  
  Yes
  - Repair the (W20) Washer Pump Motor Control circuit for a short to ground.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Go To 5
(W10) WASHER PUMP MOTOR CONTROL CIRCUIT SHORT TO GROUND

Fig 3: Checking Front Washer Pump Motor Control Circuit For A Short To Ground
Courtesy of CHRYSLER GROUP, LLC
1. Measure the resistance between ground and the (W10) Washer Pump Motor Control circuit.
  Is the resistance below 5.0 Ohms?
  
  Yes
  - Repair the (W10) Washer Pump Motor Control circuit for a short to ground.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Replace the TIPM in accordance with the Service Information.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .