Diagnostic Test

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.

INTERMITTENT CONDITION
1. Turn the ignition on.
2. With the scan tool, clear all TIPM DTCs.
3. Turn the Park Lamps on.
4. With the scan tool read the DTC information.
  Does the scan tool read: B165D-PARK LAMP CONTROL CIRCUIT HIGH?
  
  Yes
  - Go To 2
  No
  - The condition that caused the symptom is currently not present. Inspect the related wiring for a possible intermittent condition. Look for any chafed, pierced, pinched, or partially broken wires.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
LEFT AND RIGHT PARK LAMPS OR BULBS
1. Turn the ignition off.
2. Inspect the Left and Right Park Lamps and bulb assemblies.
  Are the inoperative lamps and bulbs OK?
  
  Yes
  - Go To 3
  No
  - Replace the Inoperative lamps or bulbs in accordance with the Service Information.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
(L217) PARK LAMP CONTROL CIRCUIT OPEN
1. Turn the ignition off.
2. Disconnect the TIPM C3 harness connector.
3. Disconnect the Left and Right Park Lamp harness connectors.
4. Measure the resistance of the (L217) Park Lamp Control circuit.
  Is the resistance above 5.0 Ohms?
  
  Yes
  - Repair the (L217) Park Lamp Control circuit for an open condition.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Replace the Totally Integrated Power Module (TIPM) in accordance with the Service Information. Refer to MODULE, TOTALLY INTEGRATED POWER (TIPM), REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .