Sensor, Fuel Tank Pressure: Removal: Removal

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Fuel Tank Pressure Sensor Electrical Connector

Courtesy of CHRYSLER GROUP, LLC

Disconnect and isolate the negative battery cable.
Remove the fuel filler cap to relieve tank pressure.
Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
Remove the left rear wheel splash shield. Refer to SHIELD, SPLASH, REAR WHEELHOUSE, REMOVAL .
Disconnect the fuel tank pressure sensor electrical connector (1).

Fig 2: Retaining Tab & Fuel Tank Pressure Sensor
Courtesy of CHRYSLER GROUP, LLC
Carefully raise the retaining tab (2), rotate and remove the fuel tank pressure sensor (1) from the fuel tank vent tube.

Fig 3: Fuel Tank Pressure Sensor Seal
Courtesy of CHRYSLER GROUP, LLC
The fuel tank pressure sensor seal (1) can be reused if not damaged.