LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 482 (Wiper System & Washer System (Service Information)) >> Pump, Windshield Washer >> Installation >> Installation

Pump, Windshield Washer: Installation: Installation

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

A new grommet is required for installation of a new or reused washer pump motor.

  1. Firmly grasping pump by hand twist and push into reservoir. Care must be taken not to tear grommet or puncture reservoir.
  2. If fascia was partially removed, reinstall bumper fascia as needed. Refer to FASCIA, FRONT, INSTALLATION .
  3. Refill reservoir with the washer solvent.
  4. Reconnect the negative cable to the battery.
scientia non olet · About LEMON Manuals