DECKLID Service Position

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Hydraulic Pump Valve

Courtesy of CHRYSLER GROUP, LLC

WARNING:

The decklid and attached components are extremely heavy and must be lifted with the assistance of a second individual. Failure to do so could result in personal injury or vehicle damage.

NOTE:

This procedure is not necessary in it's entirety if the decklid will tilt rearward with the power folding top switch. In this case stop the folding top open event prior to the decklid leading edge closing downward and release the conventional decklid latch with the latch release cable. Proceed to Step 4 for the remainder of the procedure.

Conventionally open decklid with the key.
Open the hydraulic pump valve (3) by turning counterclockwise (1).

Fig 2: Deckbar Cylinder Manual Movement
Courtesy of CHRYSLER GROUP, LLC
Push down on both deckbar cylinder's (2) until they have reached the cylinder stops (3). As the cable assembly (1) moves with the cylinder the decklid forward latches will release.

Fig 3: Decklid Assembly
Courtesy of CHRYSLER GROUP, LLC

WARNING:
Personal injury or vehicle damage may occur if the decklid is moved forward once in the service position. The decklid will remain in the service position unassisted, however, will close rapidly and with great force if moved forward.
With the help of an assistant, lift the complete decklid assembly upward and backward into the service position.
Insert a prop rod between the deckbar latch and the striker.
Close the hydraulic pump valve by turning the valve clockwise Do Not over tighten the valve .