Switch, EVIC Control: Removal: Removal: SEBRING

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Cover, Two Screws, Steering Wheel Spoke Front Bezel & Steering Wheel

Courtesy of CHRYSLER GROUP, LLC

Disconnect and isolate the battery negative cable.
Remove the driver airbag assembly from the steering wheel. Refer to AIR BAG, DRIVER, REMOVAL .
From the back of the steering wheel (4), remove the screws (2) that secure the front bezel to the rear cover (1) of the steering wheel.
NOTE:
Depending on model, there may be additional screws securing the bezel to the steering wheel.

Fig 2: Electronic Vehicle Information Center (EVIC) Switch Pod, Spoke Bezel And Screws
Courtesy of CHRYSLER GROUP, LLC
From the face of the steering wheel, remove the screws (2) as needed, that secure the front spoke bezel (5) to the steering wheel armature within the steering wheel hub cavity.
Using a trim stick (special tool # (special tool #C-4755, Trim Stick)) or equivalent, carefully pry at the parting line between the front spoke bezel and the steering wheel rear cover enough to unsnap the two horizontal members of the bezel from those of the rear cover.
Pull the front spoke bezel away from the steering wheel far enough to access and disconnect the steering wheel wire harness connections from the Electronic Vehicle Information Center (EVIC) switch pod (1).

Fig 3: Steering Wheel Spoke Front Bezel, Screws, EVIC Switch Pod And Mounting Tabs
Courtesy of CHRYSLER GROUP, LLC
From the back of the steering wheel spoke front bezel (4), remove the three screws (2) that secure the EVIC switch pod (3) mounting tabs to the bezel.
Remove the switch from the bezel.