LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 477 (Message Center (Service Information)) >> Switch, EVIC Control >> Installation >> Installation >> SEBRING

Switch, EVIC Control: Installation: Installation: SEBRING

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Steering Wheel Spoke Front Bezel, Screws, EVIC Switch Pod And Mounting Tabs
GC0144478Courtesy of CHRYSLER GROUP, LLC
  1. Position the Electronic Vehicle Information center (EVIC) switch pod (3) to the back of the steering wheel spoke front bezel (4).
  2. Install and tighten the three screws (2) that secure the switch mounting tabs to the bezel. Tighten the screws securely.
  3. Position the front spoke bezel close enough to the steering wheel to reconnect the steering wheel wire harness connections to the Electronic Vehicle Information Center (EVIC) switch pod and the speed control switch pod connector receptacles (3).
    Fig 2: Electronic Vehicle Information Center (EVIC) Switch Pod, Spoke Bezel And Screws
    GC0144547Courtesy of CHRYSLER GROUP, LLC
  4. Position the front spoke bezel (5), EVIC switch pod (1) to the steering wheel. Be certain that the steering wheel wire harness is routed between the upper bezel stanchions and the inside circumference of the steering wheel hub cavity so that the wiring will not be pinched when the driver airbag is reinstalled.
  5. Use hand pressure to squeeze the horizontal spokes of both the front spoke bezel and the steering wheel rear cover together until all of the snap features are fully engaged.
  6. Install and tighten the screws as needed that secure the stanchions of the front spoke bezel to the steering wheel armature within the steering wheel hub cavity. Tighten the screws securely.
    NOTE:

    Depending on model, there may be additional screws securing the bezel to the steering wheel.

    Fig 3: Rear Cover, Two Screws, Steering Wheel Spoke Front Bezel & Steering Wheel
    GC0144364Courtesy of CHRYSLER GROUP, LLC
  7. From the back of the steering wheel (4), install and tighten the lower screws (2) as needed that secure the spoke of the rear cover (1) to the lower spoke of the steering wheel front bezel (3). Tighten the screws securely.
  8. Install the driver airbag assembly (2). Refer to AIR BAG, DRIVER, INSTALLATION .
  9. Do not reconnect the battery negative cable at this time. The Supplemental Restraint System (SRS) verification test procedure should be performed following service of any SRS component. Refer to STANDARD PROCEDURE .
  10. Connect the negative battery cable.
scientia non olet · About LEMON Manuals