Sensor, Crankshaft Position: Removal: 3.6L

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Heat Shield

Courtesy of CHRYSLER GROUP, LLC

The crankshaft position (CKP) sensor is mounted into the right rear side of the cylinder block.

Disconnect and isolate the negative battery cable.
Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
Push back the heatshield (1) from the crankshaft position (CKP) sensor.

Fig 2: Electrical Connector
Courtesy of CHRYSLER GROUP, LLC
Disconnect the electrical connector (1) from the crankshaft position (CKP) sensor.

Fig 3: Sensor Mounting Bolt & Sensor
Courtesy of CHRYSLER GROUP, LLC
Remove the sensor mounting bolt (2).
Carefully twist the sensor (1) from the cylinder block.

Fig 4: CKP Sensor O-Ring
Courtesy of CHRYSLER GROUP, LLC
The CKP sensor O-ring (1) can be reused if not damaged.