LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 474 (Ignition System (Service Information)) >> Sensor, Camshaft Position >> Removal >> 2.4L Rear

2.4L Rear

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Rear Cam Sensor Shield Installed
GC0082376Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable.
  2. Disconnect the electrical connector from the sensor.
  3. Remove the nut retaining the heat shield.
    Fig 2: Rear Cam Sensor Shield Removed
    GC0082377Courtesy of CHRYSLER GROUP, LLC
  4. Pull the heat shield out to uncover the sensor.
  5. Remove the mounting bolt.
    Fig 3: Cam Sensor
    GC0082375Courtesy of CHRYSLER GROUP, LLC
  6. Remove the sensor.
scientia non olet · About LEMON Manuals