Section 469 (Starting System (Service Information)): Starter: Removal: 2.4L

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Mounting Bolts

Courtesy of CHRYSLER GROUP, LLC

Remove air cleaner box and air tube.
Disconnect and isolate the battery negative cable
Remove starter motor mounting bolt.

Fig 2: Throttle Body Electrical Connector
Courtesy of CHRYSLER GROUP, LLC
Disconnect the electrical connector at throttle body.

Fig 3: Throttle Body Bracket
Courtesy of CHRYSLER GROUP, LLC
Remove throttle body bolts and remove throttle body.

Fig 4: Rotating Starter
Courtesy of CHRYSLER GROUP, LLC
Push starter under intake manifold.
Tip starter nose toward cooling module.
Pull starter up and out.

Fig 5: Starter Electrical Connectors
Courtesy of CHRYSLER GROUP, LLC
Disconnect starter motor wiring.
Remove starter motor from vehicle.