LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 469 (Starting System (Service Information)) >> Starter >> Installation >> 3.6L

Section 469 (Starting System (Service Information)): Starter: Installation: 3.6L

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Starter Solenoid Electrical Connector, Solenoid Stud, Starter Mounting Bolts & Starter Assembly
GC0144659Courtesy of CHRYSLER GROUP, LLC
  1. Position the starter (3) inside the transmission.
  2. Install the starter mounting bolts (4) and tighten to 55 N.m (41 ft. lbs.).
  3. Connect the starter solenoid electrical connector (1) to starter solenoid terminal.
  4. Install the battery cable and nut to the solenoid stud (2). Tighten the nut to 10 N.m (86 in. lbs.).
  5. Install the starter solenoid heat shield.
    Fig 2: Bolts & Engine Mount Bracket
    GC0147026Courtesy of CHRYSLER GROUP, LLC
  6. Install the engine mount bracket (1) with three bolts (2) tightened to 55 N.m (41 ft. lbs.).
  7. Install the engine mount through bolt and tighten to 61 N.m (45 ft. lbs.).
    Fig 3: Guide Retainer Plate, Catalytic Converter, Exhaust Manifold & Bolts
    GC0147006Courtesy of CHRYSLER GROUP, LLC
  8. Install the catalytic converter. Refer to CONVERTER, CATALYTIC, INSTALLATION .
  9. Connect the negative battery cable and tighten nut to 5 N.m (4.5 in. lbs.).
scientia non olet · About LEMON Manuals