Section 468 (Charging System (Service Information)): Generator: Installation: 3.6L
WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.
- Position the generator (1) onto the engine mounting bracket.
- Install the two upper mounting bolts (2) and the lower mounting bolt to generator (1). Tighten bolts to 42 N.m (31 ft. lbs.).
- Connect the field wire connector (3) to the generator.
- Install B+ terminal and nut to generator mounting stud. Tighten nut to 10 N.m (88.5 in. lbs.)
- Snap the plastic protective cover over the B+ terminal.
- Install the accessory drive belt. Refer to BELT, SERPENTINE, INSTALLATION .
- Install the engine cooling fan assembly. Refer to FAN, COOLING, INSTALLATION .
- Install the engine oil dipstick tube.
- Install the air cleaner body. Refer to BODY, AIR CLEANER, INSTALLATION .
- Connect negative battery cable (2), tighten nut (1) to 4.5 N.m (40 in. lbs.).
- Start the engine and verify the generator is functioning properly.