LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 457 (Restraints System (Service Information)) >> Buckle, Seat Belt >> Installation >> Rear

Buckle, Seat Belt: Installation: Rear

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Rear Seat Belt Buckle
GC0122053Courtesy of CHRYSLER GROUP, LLC
NOTE:

On left side buckle, make sure you have the center seat belt webbing (3) anchor underneath the buckle before you install and tighten nut.

  1. Place buckle (1 or 4) on stud and install nut (2). Tighten nut to 101 N.m (74.5 ft. lbs.).
  2. Install rear seat cushion. Refer to COVER, SEAT CUSHION, INSTALLATION , COVER, SEAT CUSHION, FRONT, INSTALLATION or COVER, SEAT CUSHION, INSTALLATION .
scientia non olet · About LEMON Manuals