LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 455 (Antilock Brake System (Abs) (Service Information)) >> Hydraulic/Mechanical >> Integrated Control Unit (ICU) >> Removal >> 3.6L Engine

3.6L Engine

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Brake Pedal Holding Tool
GC0098418Courtesy of CHRYSLER GROUP, LLC
NOTE:

Before proceeding, refer to CAUTION and WARNING .

  1. Disconnect and isolate battery negative cable from battery post.
  2. Using a brake pedal holding tool as shown in illustration, depress the brake pedal past its first 25 mm (1 inch) of travel and hold it in this position. This will isolate the master cylinder from the brake hydraulic system and will not allow the brake fluid to drain out of the master cylinder reservoir while the lines are disconnected.
  3. Remove the engine appearance cover.
  4. Remove the engine upper intake manifold. Refer to MANIFOLD, INTAKE, REMOVAL for 2.4L or MANIFOLD, INTAKE, REMOVAL for 3.6L.
    Fig 2: Brake Tubes At ICU
    GC0079880Courtesy of CHRYSLER GROUP, LLC
  5. Remove the primary (4) and secondary (1) brake tubes (from master cylinder) at the hydraulic control unit (7).
  6. Remove the remaining brake tubes (2, 3, 5, 6) at the hydraulic control unit (7).
  7. Pull the brake tube bundle routing clip (with tubes) loose from the stud on the right side of the dash panel.
    Fig 3: ABM Connector Release Tabs
    GC0079881Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    Use the illustration in the following step to release the ABM harness connector cover. It shows the location of the release tabs.

    Fig 4: Anti-Lock Brake Module Wiring Harness Connector
    GC0081322Courtesy of CHRYSLER GROUP, LLC
    1 - ABM (PART OF ICU)
    2 - WIRING HARNESS CONNECTOR
  8. Disconnect the ABM harness connector from the Antilock Brake Module (ABM). To do so:
    1. Depress the tabs on each side of the connector cover, then
    2. Pull outward and upward on the lower half of the cover until it locks into position pointing straight outward (2). The connector can then be pulled straight outward off the ABM (1).
    Fig 5: ICU Mounting
    GC0082347Courtesy of CHRYSLER GROUP, LLC
  9. Loosen, but do not remove, the two mounting screws (2) attaching the ICU (1) mounting bracket to the body.
  10. Lift the ICU and mounting bracket (1) off the mounting screws (2).
    Fig 6: Removing/Installing ICU - 3.5L
    GC0120850Courtesy of CHRYSLER GROUP, LLC
  11. Move the brake tubes around as necessary without bending them and remove the ICU with bracket (1) through the opening above the rear cylinder head cover (2).
  12. To separate the ABM from the HCU, refer to INTEGRATED CONTROL UNIT (ICU), DISASSEMBLY .
scientia non olet · About LEMON Manuals