3.6L Coolant Crossover
WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.
- Clean gasket sealing surfaces.
- Install new gasket onto the coolant crossover.NOTE:
The shorter M6 mounting bolts (2), bolt directly to the engine timing cover.
- Hand tighten the M6 mounting bolts. Tighten the bolts in a criss cross pattern to 12 N.m (106 in. lbs.).
- Install the heater supply hose to the coolant crossover (1).
- Install the thermostat housing. Refer to THERMOSTAT, INSTALLATION .