LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 453 (Engine Cooling System) >> Engine >> Thermostat >> Installation >> 2.4L - Primary Thermostat

2.4L - Primary Thermostat

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Primary Thermostat
GC0120915Courtesy of CHRYSLER GROUP, LLC
1 - COOLANT HOSE
2 - INLET HOUSING
3 - BOLT
  1. Position thermostat into the water plenum, aligning air bleed with the location notch on inlet housing (2).
  2. Install inlet housing (2) onto coolant adapter. Tighten bolts to 18 N.m (159 in. lbs.).
  3. Connect coolant hose (1).
  4. Install air filter housing.
  5. Fill cooling system. Refer to STANDARD PROCEDURE .
scientia non olet · About LEMON Manuals