LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 452 (Body - Interior & Exterior) >> Convertible Top, Retractable Hard Top Unique Components >> Top, Folding >> Removal >> Rear Panel

Rear Panel

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Heated Glass Electrical Connector, Rear Panel & Fasteners
GC0122888Courtesy of CHRYSLER GROUP, LLC
  1. Remove the mid/rear headliner as necessary. Refer to HEADLINER, REMOVAL  - CONVERTIBLE TOP, CONVERTIBLE SOFT TOP UNIQUE COMPONENTS or HEADLINER, REMOVAL  - CONVERTIBLE TOP, RETRACTABLE HARD TOP UNIQUE COMPONENTS.
  2. Mark the location of the hinge bracket to rear panel (4) to aid in installation.
  3. Disconnect the heated glass connectors (3) and remove the harness from the rear panel.
  4. Remove the lower fastener (2).
  5. Remove the two lower fasteners (1), leaving the top one on each side, that secure the rear panel to the hinge assemblies.
  6. With the help of assistant, remove remaining fasteners and remove rear panel.
scientia non olet · About LEMON Manuals