LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 450 (Lamps/Lighting - Exterior (Service Information)) >> Unit, Front Lamp >> Removal >> Bulbs >> CHRYSLER >> Front Turn Signal/Daytime Running Lamp (DRL)

Front Turn Signal/Daytime Running Lamp (DRL)

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the battery negative cable.
  2. Reach behind the front lamp unit to access the bulbs from the back of the lamp housing.
  3. Disconnect the Front End Module (FEM) wire harness connector from the front turn signal/DRL bulb socket connector receptacle (3).
  4. Firmly grasp the front turn signal/DRL bulb socket on the back of the front lamp unit housing and rotate it counterclockwise about 30 degrees to unlock it.
  5. Pull the socket and bulb straight out from the keyed opening in the housing.
  6. Pull the base of the bulb straight out of the socket.
scientia non olet · About LEMON Manuals