Lamp, License Plate: Removal: Bulb

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Bulb & Socket

Courtesy of CHRYSLER GROUP, LLC

Disconnect and isolate the battery negative cable.
On Chrysler models, remove the license plate lamp from the deck lid handle and light bar. Refer to LAMP, LICENSE PLATE, REMOVAL .
On Dodge models, remove the license plate lamp from the rear fascia. Refer to LAMP, LICENSE PLATE, REMOVAL .
Pull the base of the bulb (2) straight out of the socket (1).