Lamp, License Plate: Installation: Bulb

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

Always use the correct bulb size and type for replacement. An incorrect bulb size or type may overheat and cause damage to the lamp, the socket or the lamp wiring.

Fig 1: Bulb & Socket

Courtesy of CHRYSLER GROUP, LLC

Align the base of the license plate lamp bulb (2) with the socket (1).
Push the bulb straight into the socket until the base is firmly seated.
On Chrysler models, reinstall the license plate lamp into the deck lid handle and light bar. Refer to LAMP, LICENSE PLATE, INSTALLATION .
On Dodge models, reinstall the license plate lamp into the rear fascia. Refer to LAMP, LICENSE PLATE, INSTALLATION .
Reconnect the battery negative cable.