Lamp, Fog: Installation: Lamp
WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.
- From the back of the front fascia, position the front fog lamp and mounting ring (1) onto the back of the fog lamp bezel (2).
- Align the four slots in the front fog lamp mounting ring with the four latch features (4) integral to the back of the fog lamp bezel.
- Press firmly and evenly on the fog lamp mounting ring until the four latch features snap into place through the mounting ring slots.
- Reconnect the engine compartment wire harness connector to the front fog lamp bulb connector receptacle (3).
- Reinstall the front lower fascia closeout panel. Refer to FASCIA, FRONT LOWER, CLOSEOUT, INSTALLATION .
- Lower the vehicle.
- Reconnect the battery negative cable.
- Confirm proper front fog lamp alignment. Refer to STANDARD PROCEDURE .