3.6L Engine

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Return Hose At Return Tube

Courtesy of CHRYSLER GROUP, LLC

NOTE:

Before proceeding. Refer to WARNING .

Siphon as much fluid as possible from the power steering fluid reservoir.
Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
Remove the return hose (1) at the return tube (2) and allow any fluid in the hose to drain. If equipped with a screw-clamp, be sure to save the original clamp for reinstallation.

Fig 2: Hose Fitting & Pump
Courtesy of CHRYSLER GROUP, LLC
Remove the pressure hose (2) at the pump (1).

Fig 3: Pressure Hose, Return Hose & Tube Nuts
Courtesy of CHRYSLER GROUP, LLC
Unscrew the tube nut (2), then remove the return hose (1) at the steering gear.
Unscrew the tube nut (3), then remove the pressure hose (4) at the steering gear.

Fig 4: Power Steering Hose Routing Clamps & Screws
Courtesy of CHRYSLER GROUP, LLC
Remove the screws (1) securing the power steering hose routing clamps (2) to the rear of the crossmember.
Remove the power steering pressure hose from the vehicle.