Cooler, Power Steering: Removal: Removal

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Before proceeding. Refer to WARNING .

Siphon as much fluid as possible from the power steering fluid reservoir.
Raise and support the vehicle. Refer to HOISTING, STANDARD PROCEDURE .
If equipped, remove the belly pan below the engine.
Remove the lower fascia valance.

Fig 1: Power Steering Fluid Cooler Line, Return Hoses, Clamps & Push Pins
Courtesy of CHRYSLER GROUP, LLC
Remove the hose clamps (5) attaching the fluid return hoses (1) to the power steering fluid cooler line (3). Separate the return hoses from the cooler line.
Remove the two cooler mounting push pins (4) at the bumper reinforcement (2).
Remove the cooler line (3) from the vehicle.