Valves, Intake And Exhaust: Removal: Removal

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Valve Spring & Valve Spring Retainer

Courtesy of CHRYSLER GROUP, LLC

Remove the cylinder head(s). Refer to CYLINDER HEAD , REMOVAL .
NOTE:
If the springs are to be reused, identify their positions so that they can be reassembled into their original locations. Number 5 cylinder exhaust valve spring shown in illustration, all other valve springs similar.
Remove the valve spring(s) (2). Refer to SPRING(S), VALVE, REMOVAL .

Fig 2: Inspecting Valve Margin
Courtesy of CHRYSLER GROUP, LLC

CAUTION:
Before removing the valves, remove any burrs from the valve stem retainer lock grooves (2) and stem tip (1) to prevent damage to the valve guides.
Remove the valve(s) (3). Identify each valve to ensure installation in the original location.

Fig 3: Spring Seat, Valve Guide Seal & Garter Spring
Courtesy of CHRYSLER GROUP, LLC
If required, remove the valve guide seal (1) and spring seat (3). Refer to SEAL(S), VALVE GUIDE, REMOVAL .