Seal(S), Valve Guide: Installation: Installation

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Valve Spring Seat

Courtesy of CHRYSLER GROUP, LLC

If removed, install the valve(s). Refer to VALVES, INTAKE AND EXHAUST, INSTALLATION .
NOTE:
Reassemble the valves into their original locations. If the valves or valve seats have been refinished, verify that the valve stem tip height is within specification. Refer to SPECIFICATIONS . Number 5 cylinder exhaust valve shown in illustration, all other valves similar.
If removed, install the spring seat (1) over the valve guide.

Fig 2: Installing Valve Guide Seal
Courtesy of CHRYSLER GROUP, LLC
Apply engine oil to the lip of the valve guide seal (3). Install the valve guide seal (3) over the valve stem. Using an appropriate driver (1), push the seal firmly and squarely over the valve guide. Do Not Force the seal against the top of guide.
NOTE:
Ensure that the garter spring (2) is intact around the top of the valve guide seal (3). Number 5 cylinder exhaust valve guide seal shown in illustration, all other valves similar.

Fig 3: Valve Spring & Valve Spring Retainer
Courtesy of CHRYSLER GROUP, LLC

NOTE:
If the valve springs are being reused, reassemble them into their original locations. Number 5 cylinder exhaust valve spring shown in illustration, all other valves similar.
Install the valve spring(s) (2). Refer to SPRING(S), VALVE, INSTALLATION .