LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 444 (2.4L Engine (Service Information)) >> Valve Timing >> Chain And Sprockets, Timing >> Installation >> Crankshaft Sprocket

Crankshaft Sprocket

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Crankshaft Sprocket
GC0121532Courtesy of CHRYSLER GROUP, LLC
  1. Install crankshaft sprocket (1) onto crankshaft.
    Fig 2: Oil Pump Drive Chain, Oil Pump Drive Chain Tensioner & Timing Marks On Chain
    GC0121533Courtesy of CHRYSLER GROUP, LLC
  2. Install oil pump drive chain. Verify that Oil pump is correctly timed (1, 2, 5, 6).
    Fig 3: Pushing Tensioner Piston Back Into Tensioner Body
    GC0121534Courtesy of CHRYSLER GROUP, LLC
  3. Reset oil pump drive chain tensioner by pushing plunger inward and install tensioner pin (special tool #8514, Pins, Tensioner).
    Fig 4: Oil Pump Drive Chain, Oil Pump Drive Chain Tensioner & Timing Marks On Chain
    GC0121533Courtesy of CHRYSLER GROUP, LLC
  4. Install oil pump drive chain tensioner (3) and remove Tensioner Pin (special tool #8514, Pins, Tensioner) (4).
  5. Install timing chain. Refer to CHAIN AND SPROCKETS, TIMING, INSTALLATION .
  6. Install oil pan. Refer to PAN, OIL, INSTALLATION .
  7. Fill engine with oil. Refer to STANDARD PROCEDURE .
  8. Start engine and check for leaks.
scientia non olet · About LEMON Manuals