LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 440 (Front Suspension & Wheel Alignment) >> Front >> Link, Stabilizer Bar >> Installation >> Installation

Link, Stabilizer Bar: Installation: Installation

WARNING: This page is about a different car, the 2013 Dodge Avenger and 2013 Chrysler 200. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: View Of Stabilizer Link Mounting To Bar
GC0120772Courtesy of CHRYSLER GROUP, LLC
  1. Attach the stabilizer bar link (1) to the stabilizer bar (2). Install and tighten the nut (3) while holding the stabilizer bar link lower stud stationary. Tighten the nut to 48 N.m (35 ft. lbs.).
    Fig 2: Strut Mounting To Knuckle
    GC0082326Courtesy of CHRYSLER GROUP, LLC
  2. Attach the stabilizer bar link (1) to the strut (3). Install and tighten the nut (4) while holding the stabilizer bar link stud stationary. Tighten the nut to 48 N.m (35 ft. lbs.).
    Fig 3: Tire & Wheel Mounting
    GC0082325Courtesy of CHRYSLER GROUP, LLC
  3. Install tire and wheel assembly (1). Refer to INSTALLATION . Install and tighten wheel mounting nuts (3) to 135 N.m (100 ft. lbs.).
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals