Valve, Short Runner: Installation: Installation

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Short Runner Valve Actuator Rubber O-Ring Seal

Courtesy of CHRYSLER GROUP, LLC

Install a new short runner valve actuator rubber O-ring seal (1).

Fig 2: Short Runner Valve Actuator Retaining Bolts
Courtesy of CHRYSLER GROUP, LLC
Position the short runner valve actuator, install the retaining bolts (1) and tighten to 5 N.m (44 in. lb.).

Fig 3: Intake Manifold Retaining Bolt Removal & Tightening Sequence
Courtesy of CHRYSLER GROUP, LLC
Install the intake manifold and throttle body as an assembly. Refer to MANIFOLD, INTAKE, GAS, INSTALLATION, 5.7L .

Fig 4: Battery
Courtesy of CHRYSLER GROUP, LLC
Connect the negative battery cable (1).