LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 392 (Passive Entry Module (PEM) (Service Information) 2500 Hd & 3500 Hd) >> Antenna, Passive Entry >> Removal >> B-Pillar

Antenna, Passive Entry: Removal: B-Pillar

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Antenna Connector, Door Wire Harness Connector & Screws
GC0154410Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the battery negative cable.
  2. Remove the trim panel from the inside of the door. Refer to PANEL, DOOR TRIM, REMOVAL .
  3. Disconnect the door wire harness connector (2) from the Low Frequency (LF) antenna (1) connector receptacle.
  4. Remove the two screws (3) that secure the LF antenna to the door inner panel (4).
  5. Remove the LF antenna from the door.
scientia non olet · About LEMON Manuals