Lamp, Vanity: Removal: Removal
WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Vehicles equipped with optional vanity lamps have a mirror with a single lamp that is integral to each sun visor. Each lamp is independently controlled by an integral switch that is automatically actuated by the mirror cover. The bulb types and service procedures are identical for each of these lamps.
- Disconnect and isolate the battery negative cable.
- Insert a small flat-bladed screwdriver on either side near the top or the bottom between the vanity lamp lens (2) and the lamp housing of the sun visor (1).
- Carefully pry the lens outward until it unsnaps from the lamp housing.
- Using small needle-nose pliers, carefully grasp the bulb (2) and pull the base out of the lamp socket.