Diagnostic Test

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

TEST FOR INTERMITTENT CONDITION
1. Turn the ignition on.
2. With the scan tool, record and erase the DTCs.
3. Block the Light Sensor in the Interior Rearview Mirror.
4. Shift the transmission to Drive (engine not running)
5. Turn the drivers side turn signal on.
6. Turn the park lamps on.
7. Turn the rear defogger on, if equipped with heated mirror.
8. Press and release the Mirror Select switch to select the Driver Outside Rearview Mirror.
9. Fold And Unfold the mirrors several time, if equipped with folding mirrors.
10. Operate the Mirror Adjust switch in all directions several times while monitoring the scan tool for DTCs.
  NOTE:
  After adjusting the mirror in one direction wait at least two seconds before adjusting the mirror in the opposite direction, as this will allow time for an active fault to set if present.
11. With the scan tool, read the active DTCs.
  Does the scan tool display; B1F05-11-ELECTROCHROMATIC CONTROL CIRCUIT - CIRCUIT SHORT TO GROUND as active?
  
  Yes
  - Go To 2
  No
  - Test complete, the condition or conditions that originally set this DTC are not present at this time. Using the wiring diagrams as a guide, check all related splices and connectors for signs of water intrusion, corrosion, pushed out or bent terminals and correct pin tension.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
INSPECT MIRROR CONNECTIONS
1. Turn the ignition off.
2. Disconnect the Driver Outside Rearview Mirror C1 and C2 connectors at the Drivers Door Module.
3. Inspect the wiring harness, connectors and the Door Module for any breaks, bent terminals or crossed wiring.
  Were there any problems found?
  
  Yes
  - Repair as necessary.
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Go To 3
MIRROR OR MODULE
1. Turn the ignition on.
2. Block the Light Sensor in the Interior Rearview Mirror.
3. Shift the transmission to Drive (engine not running)
4. With the scan tool, record and erase DTCs.
5. Turn the drivers side turn signal on.
6. Fold And Unfold the mirrors several time, if equipped with folding mirrors.
7. Turn the rear defogger on, if equipped with heated mirror.
8. Turn the park lamps on.
9. Press and release the Mirror Select switch to select the Driver Outside Rearview Mirror.
10. Operate the Mirror Adjust switch in all directions several times while monitoring the scan tool for DTCs.
  NOTE:
  After adjusting the mirror in one direction wait at least two seconds before adjusting the mirror in the opposite direction, as this will allow time for an active fault to set if present.
11. With the scan tool, read DTCs.
  NOTE:
  Check for a change in DTCs.
  
  Does the scan tool display; B1F05-13-ELECTROCHROMATIC CONTROL CIRCUIT - CIRCUIT OPEN as active?
  
  Yes
  - With the circuit now OPEN that indicates the short is NOT in the Module. Replace the mirror in accordance with the Service Information. Refer to MIRROR, OUTSIDE REARVIEW, REMOVAL and MIRROR, OUTSIDE REARVIEW, GLASS, REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Replace the Door Module in accordance with the Service Information. Refer to MODULE, DOOR, REMOVAL .
  - Perform the BODY VERIFICATION TEST. Refer to STANDARD PROCEDURE .