LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 359 (Battery System (Service Information) 2500 Hd & 3500 Hd) >> Tray, Battery >> Installation >> Installation

Tray, Battery: Installation: Installation

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Removing/Installing Battery Tray (Left Side) 2 Of 2
GC0083471Courtesy of CHRYSLER GROUP, LLC
  1. Position the battery tray assembly (1) and install the retaining bolts (2).
  2. Connect the left front fender ground wire.
  3. Install the cruise servo (3) (if equipped) and retaining screws.
  4. Install the left front wheelhouse splash shield. Refer to SHIELD, SPLASH, FRONT WHEELHOUSE, INSTALLATION .
    Fig 2: Removing/Installing Battery Tray (Left Side) 1 Of 2
    GC0083470Courtesy of CHRYSLER GROUP, LLC
  5. Install the anti-lock brake controller (if equipped).
  6. Install the purge solenoid (6) on its mounting bracket.
  7. Connect the wire harness retainers on the battery tray assembly.
  8. Install the Power Distribution Center (PDC) (5).
  9. Install the battery (3). Refer to BATTERY, INSTALLATION .
scientia non olet · About LEMON Manuals