LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 359 (Battery System (Service Information) 2500 Hd & 3500 Hd) >> Cables, Battery >> Removal >> Left-Side >> Left Side Positive

Left Side Positive

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Battery Cables & Components
GC0155269Courtesy of CHRYSLER GROUP, LLC
  1. Disconnect and isolate the negative battery cable (3).
  2. Remove nut (7) and the wire harness (8).
  3. Remove nut (6) and the positive battery cable (9) from clamp (5).
  4. Disconnect the battery positive cable terminal clamp (5) from battery.
    Fig 2: Cable, Nut & Wire Harness Retainer
    GC0155362Courtesy of CHRYSLER GROUP, LLC
  5. Disconnect the wire harness retainer (3) at the Power Distribution Center (PDC).
  6. Remove nut (2) and the cable (1) from the PDC.
  7. Disconnect the battery cable retaining pushpin securing the cable to the battery tray.
    Fig 3: Starter 6.7L Diesel
    GC0108135Courtesy of CHRYSLER GROUP, LLC
  8. Raise the vehicle on a hoist. Refer to HOISTING, STANDARD PROCEDURE .
  9. Lift the terminal cap from the starter stud.
  10. Remove the nut (2) securing the B+ cable to the
  11. Disconnect starter solenoid wire harness connector (3).
  12. Lower the vehicle.
  13. Disconnect any remaining pushpin's securing the cable to the vehicle.
  14. Remove the battery positive cable from the vehicle.
scientia non olet · About LEMON Manuals