LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 359 (Battery System (Service Information) 2500 Hd & 3500 Hd) >> Cables, Battery >> Installation >> Left-Side >> Left Side Positive

Left Side Positive

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Starter 6.7L Diesel
GC0108135Courtesy of CHRYSLER GROUP, LLC
  1. Position the battery positive cable (1, 3) in the vehicle.
  2. Connect the battery cable retaining pushpin's securing the cable.
  3. Raise the vehicle on a hoist. Refer to HOISTING, STANDARD PROCEDURE .
  4. Install the B+ cable nut (2) and tighten to 14 N.m (124 in. lbs.).
  5. Secure the terminal cap onto the starter stud.
  6. Connect starter solenoid wire harness connector (3).
  7. Lower the vehicle.
    Fig 2: Cable, Nut & Wire Harness Retainer
    GC0155362Courtesy of CHRYSLER GROUP, LLC
  8. Install the battery cable retaining pushpin securing the cable to the battery tray.
  9. Install the cable (1) to the Power Distribution Center (PDC). Tighten nut (2) to 10 N.m (89 in lbs.).
  10. Connect the wire harness retainer (3) at the PDC.
    Fig 3: Battery Cables & Components
    GC0155269Courtesy of CHRYSLER GROUP, LLC
  11. Connect the positive cable to clamp and tighten nut to 10 N.m (89 in lbs.).
  12. Install the battery positive cable (9) to clamp (5). Tighten Nut (6) to 6 N.m (53 in. lbs.).
  13. Connect the battery positive cable terminal clamp (8). Tighten Nut (7) to 4 N.m (35 in. lbs.).
  14. Connect the battery negative cable terminal clamp (3) and tighten to 6 N.m (53 in. lbs.).
scientia non olet · About LEMON Manuals