LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 356 (Engine Cooling System - 2500 Hd & 3500 Hd) >> Engine >> Radiator, Engine Cooling >> Removal >> Gas

Radiator, Engine Cooling: Removal: Gas

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect and isolate the negative battery cable.
  2. Raise and secure the vehicle.
    Fig 1: Lower Radiator Cover
    GC0152028Courtesy of CHRYSLER GROUP, LLC
  3. Remove the lower radiator cover (2).
    Fig 2: Radiator Fan, Shroud & Bolts
    GC0087422Courtesy of CHRYSLER GROUP, LLC
  4. Drain the cooling system. Refer to STANDARD PROCEDURE .
    WARNING:

    Do not remove the cylinder block drain plugs or loosen the radiator draincock with the system hot and under pressure. Serious burns from the coolant can occur.

  5. Remove the lower radiator hose.
  6. Remove the lower fan shroud cover (1).
  7. Remove the lower electric cooling fan retainer clip.
  8. Lower the vehicle.
    Fig 3: Upper Radiator Seal & Plastic Rivets
    GC0087421Courtesy of CHRYSLER GROUP, LLC
  9. Remove the upper radiator clamp and hose.
  10. Remove the upper radiator seal push pins (1).
  11. Remove the upper radiator seal plastic rivets (2).
  12. Remove the upper radiator seal.
    Fig 4: Upper Grille Support Bolts
    GC0088987Courtesy of CHRYSLER GROUP, LLC
  13. Remove the grille. Refer to GRILLE, REMOVAL .
    Fig 5: Transmission Cooler Line & Bracket
    GC0087439Courtesy of CHRYSLER GROUP, LLC
  14. Remove the bolt from the transmission cooler line (1) to radiator (3) bracket (2).
    Fig 6: A/C Condenser/Transmission Combination Cooler, Lines, Bolts & Brackets
    GC0152027Courtesy of CHRYSLER GROUP, LLC
    NOTE:

    It is not necessary to remove the transmission cooler lines or the A/C lines from the cooler.

  15. Remove the bolt (8) that secures the condenser jumper line tapping block (7) to the right side of the radiator (5).
  16. Remove the three brackets (10) from the A/C compressor/transmission combination cooler (3).
  17. Using care, disengage the A/C condenser/transmission combination cooler mounting bracket (2) from the left side of the radiator, do not disconnect the A/C lines. 
    Fig 7: Radiator Fan, Shroud & Bolts
    GC0087422Courtesy of CHRYSLER GROUP, LLC
  18. Disconnect the electrical connector to the cooling fan.
  19. Remove the electric cooling fan (3) to radiator upper retaining clips.
  20. Remove the fan shroud mounting bolts (4) and pull up and out of the radiator tank clips. Position the shroud (2) rearward over the fan blades towards engine.
  21. Remove the fan shroud (2) and electric cooling fan (3) as an assembly.
    Fig 8: Radiator
    GC0087438Courtesy of CHRYSLER GROUP, LLC
  22. Remove the overflow hose (3) from the radiator filler neck.
  23. Remove the two radiator upper mounting bolts (2).
  24. Lift the radiator (1) straight up and out of the engine compartment. Take care not to damage cooling fins when removing.
scientia non olet · About LEMON Manuals