6.7L Diesel
WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect both negative battery cables.
- Drain the cooling system. Refer to STANDARD PROCEDURE .
- Remove air cleaner body and the turbocharger inlet tube. Refer to BODY, AIR CLEANER, REMOVAL, 6.7L .
- Remove the generator assembly. Refer to GENERATOR, REMOVAL .
- Remove bolts (1) and the water pump (2).
- Remove and discard the O-ring seal from water pump (2). Clean water pump sealing surface on cylinder block.