Diagnostic Test

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

CHECK THE DYNAMICS SENSOR INSTALLATION
NOTE:
Occupant Restraint Controller (ORC) installation and mounting bolt torque is crucial for proper operation.
1. Turn the ignition off to the lock position.
2. Check the Occupant Restraint Controller (ORC) for damaged, modified, and bent mounting brackets.
3. Check the Occupant Restraint Controller (ORC) mounting bolts for a loose or over tightened condition.
  Were any problems found?
  
  Yes
  - Repair as necessary.
  - Perform the ABS VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Go To 2
ANTI-LOCK BRAKE SYSTEM (ABS) MODULE
1. Turn the ignition off to the lock position.
2. Replace the Occupant Restraint Controller (ORC) in accordance with the Service Information. Refer to MODULE, OCCUPANT RESTRAINT CONTROLLER, REMOVAL .
3. Perform the ABS VERIFICATION TEST. Refer to STANDARD PROCEDURE .
4. Test drive the vehicle by turning the vehicle left or right in a curving manner at a velocity between 15 and 35 km/h (9 and 22 mph).
5. With the scan tool, read the DTCs.
  Does the DTC remain active?
  
  Yes
  - Replace the Anti-lock Brake System (ABS) Module in accordance with the Service Information. Refer to MODULE, ANTI-LOCK BRAKE SYSTEM, REMOVAL .
  - Perform the ABS VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Test complete.