Diagnostic Test

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

BRAKE PEDAL CALIBRATION
1. Turn the ignition on.
2. With the scan tool, read and record the ABS DTCs.
  NOTE:
  When performing the Brake Pedal Calibration routine, make sure the brake pedal is not pressed.
3. With the scan tool, under "Miscellaneous Functions" run the Brake Pedal Calibration routine.
4. Park the vehicle.
  Was the Brake Pedal Calibration routine successful?
  
  Yes
  - Test complete.
  - Perform the ABS VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Perform the Brake Pedal Calibration routine again, if still unsuccessful.
  - Go To 2
INSPECT THE BRAKE PEDAL POSITION (BPP) SENSOR FOR INCORRECT INSTALLATION, DAMAGE OR MECHANICAL FAILURE
1. Turn the ignition off.
2. Visually inspect the BPP Sensor for Improper installation, damage or mechanical failure. Refer to SWITCH, STOP LAMP, INSTALLATION .
  Were any problems found?
  
  Yes
  - Repair as necessary.
  - Perform the ABS VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Go To 3
BRAKE PEDAL POSITION (BPP) SENSOR
1. Turn the ignition off to the lock position.
2. Replace the Brake Pedal Position Sensor in accordance with the Service Information. Refer to SWITCH, STOP LAMP, REMOVAL . With the scan tool, under "Miscellaneous Functions" run the Brake Pedal Calibration routine.
3. With the scan tool, read the DTCs.
  Does the DTC remain active?
  
  Yes
  - Replace the Anti-Lock Brake System (ABS) Module in accordance with the Service Information. Refer to MODULE, ANTI-LOCK BRAKE SYSTEM, REMOVAL .
  - Perform the ABS VERIFICATION TEST. Refer to STANDARD PROCEDURE .
  No
  - Test complete.
  - Perform the ABS VERIFICATION TEST. Refer to STANDARD PROCEDURE .