Switch, Oil Pressure: Installation: Installation

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Oil Pressure Switch, Bolt & O-Ring Washer Seals

Courtesy of CHRYSLER GROUP, LLC

Using a new O-ring washer seals (3), install the oil pressure switch (1) and elbow. Tighten bolt (2) to 18 N.m (159 in. lbs.).

Fig 2: Oil Pressure Switch Wire Harness Connector
Courtesy of CHRYSLER GROUP, LLC
Connect oil pressure switch wire harness connector (1).
Connect both negative battery cables.
Start engine and check for oil leaks at the switch.