LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 350 (5.7L CNG Engine (Service Information) 2500 Hd) >> Engine Block >> Damper, Vibration >> Installation >> Installation

Damper, Vibration: Installation: Installation

WARNING: This page is about a different car, the 2013 RAM 2500 HD and 2012 RAM Pickup. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Identifying Damper Installer & A/C Hub Installer Cup
GC0087852Courtesy of CHRYSLER GROUP, LLC
CAUTION:

To prevent severe damage to the crankshaft, damper, and damper installer, thoroughly clean the damper bore and the crankshaft nose before installing damper.

  1. Position the damper onto crankshaft.
  2. Assemble the damper installer (special tool #8512A, Installer, Damper) (2), and the pressing cup (1) from A/C hub installer (special tool #6871, Installer, A/C Hub).
  3. Using the damper installer (special tool #8512A, Installer, Damper) (2), and the pressing cup (1) from the A/C hub installer (special tool #6871, Installer, A/C Hub), press the damper onto crankshaft.
    Fig 2: Installing Vibration Damper
    GC0143968Courtesy of CHRYSLER GROUP, LLC
  4. Install the crankshaft damper bolt.
  5. Position the (special tool #10386, Holder, Vibration Damper) (2), onto the vibration damper (3).
  6. Tighten the bolt to 176 N.m (130 ft. lbs.).
  7. Install the cooling fan.
    Fig 3: Accessory Drive Belt
    GC0088055Courtesy of CHRYSLER GROUP, LLC
  8. Install the radiator upper shroud and tighten the fasteners to 11 N.m (95 in. lbs.).
  9. Install the radiator upper hose.
  10. Install the accessory drive belt (1). Refer to INSTALLATIONBELT, SERPENTINE, INSTALLATION .
  11. Refill the cooling system. Refer to STANDARD PROCEDURESTANDARD PROCEDURE .
  12. Connect the negative cable to battery.
scientia non olet · About LEMON Manuals