LEMON Manuals: Even more car manuals for everyone
Home >> Chrysler >> 2011 >> 300 C, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 338 (Steering System - 2500 Hd & 3500 Hd) >> Linkage, Link And Coil >> End, Tie Rod, Link And Coil >> Removal >> RH - With Drag Link To Knuckle

RH - With Drag Link To Knuckle

WARNING: This page is about a different car, the 2013 RAM 3500 HD and 2013 RAM 2500 HD. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

All views are typical.

Fig 1: Drag Link, Tie Adjuster Sleeve, Tie Rod & Nuts/Bolts
GC0155145Courtesy of CHRYSLER GROUP, LLC
  1. Raise and support the vehicle Refer to HOISTING, STANDARD PROCEDURE .
  2. Remove the wheel.
  3. Loosen the nut/bolt (8) on the tie rod adjuster sleeve (6) as necessary.
    Fig 2: Drag Link/Tie Rod To Knuckle Nut & Cotter Key
    GC0152017Courtesy of CHRYSLER GROUP, LLC
  4. Remove the cotter key (1) and the drag link/tie rod to knuckle nut (2).
  5. Remove the tie rod (4) from the knuckle (5) with (special tool #C-3894-A, Puller, Tie Rod) and (special tool #10403, Separator, Drag Link)
  6. Remove the tie rod end (4) from the adjuster sleeve.
scientia non olet · About LEMON Manuals